Change head movement behaviour before/after job completion

Change head movement behaviour for before/after job:

  1. In Job Control X go to Settings
  2. Go to options
  3. Click on Process Options
  4. For the ‘Laser homing’ select
    1. No moves – no movement after job, only moves as needed before job to get to the start position
    2. Move to (0,0) on begin and end – always resets pre and post job to the top left hand corner
    3. Return to start position – moves the head to where the job started after the job is finished.

Reverse job start position in Job Control

If you need to start the job from the bottom of the material and work backward you can.

In Job control, go to Plate -> Plate Setup -> Start Position and choose bottom.

You still position your work piece as though it engraves from the top however this is where it will finish.

Simple tip and of course its in the manual, but putting it here for my sanity.